homestead.fyi / TROUGH

Pig Feeder Trough

A 6 ft pig trough of 2x6 ground-contact boards on two 4x4 skids with plywood ends and two 2x4 dividers.

Draft plan, generated from the model. Not yet build-tested.
72 inLength
6, at 12 in eachPigs
2 to 3 hrBuild time
$142.37Materials

Drawings All dimensions in inches

3D viewfinished
3D view
Front elevation
Front elevation 16 in 10 1/2 in
Right elevation
Right elevation 72 in 10 1/2 in
Plan viewfrom above
Plan view 16 in 72 in

Cut list: lumber Long-point lengths; angles noted

QtyStockLengthPartCut
22x416Dividerlaid flat, screwed to the side tops
22x6 GC72Bottomlaid flat
12x6 GC72Side lefton edge
12x6 GC72Side righton edge
14x4 PT72Skid front
14x4 PT72Skid back

Cut list: sheet goods

PartStockSizeNote
End front3/4 ply11 x 4
End back3/4 ply11 x 4

Lumber cutting diagram Lengths chosen for the lowest cost; 1/8 in kerf, 1/2 in end trim

2x4 x 8 ft
Divider 1 16Divider 2 16
2x6 GC x 8 ft
Bottom 1 72
2x6 GC x 8 ft
Bottom 2 72
2x6 GC x 8 ft
Side left 72
2x6 GC x 8 ft
Side right 72
4x4 PT x 8 ft
Skid front 72
4x4 PT x 8 ft
Skid back 72

Sheet cutting diagrams Dashed = openings to cut out

Sheet 1: 3/4 in plywood, 4 x 8 ft
End front11 x 4End back11 x 4

Shopping list $142.37 checked / $0.00 estimated

ItemStoreQtyEachLineNote
2x4x8 stud, SPFHome Depot1$4.15$4.15see lumber cutting diagram
2x6x8 ground-contact pressure-treatedHome Depot4$9.78$39.12see lumber cutting diagram
4x4x8 ground-contact pressure-treatedHome Depot2$11.28$22.56see lumber cutting diagram
23/32 in (3/4 in) CDX plywood, 4x8 sheetLowe's1$46.57$46.57see sheet cutting diagrams
Exterior wood screws #9 x 2.5 in, 5 lb boxHome Depot1$29.97$29.97
Total before tax$142.37
Filled dot: price read from a store listing on Oct 20, 2026. Hollow dot: estimate. Prices come from the master price list, so they change when it changes.

Build steps

  1. Cut the two bottom boards and two sides to 72 in from the cutting diagram, and the 4x4 skids.
  2. Screw the two bottom boards edge to edge across the two skids, flat, with two screws per skid.
  3. Screw a side on edge to each outer edge of the bottom boards, every 8 in.
  4. Screw the two plywood ends inside, flush with the board ends.
  5. Screw the two 2x4 dividers flat across the side tops, at 24 and 48 in, so each pair of pigs has its own space and cannot stand in it.

Before you start