homestead.fyi / WOVEN-100

Woven-Wire Fence, 100 ft

A 100 ft run of 47 in woven-wire fence between two H-braces, with T-posts every 10 ft.

Draft plan, generated from the model. Not yet build-tested.
100 ftLength
47 inHeight
8T-posts
8 to 12 hrBuild time
~$228.14Materials, part estimate

Drawings All dimensions in inches

3D viewfinished
3D view
Front elevation
Front elevation 3 1/2 in 94 in
Right elevation
Right elevation 1200 in 94 in
Plan viewfrom above
Plan view 3 1/2 in 1200 in

Cut list: lumber Long-point lengths; angles noted

QtyStockLengthPartCut
24x4 PT94Brace post start
24x4 PT94Brace post end
14x4 PT92 1/2Brace startcut to fit
14x4 PT92 1/2Brace endcut to fit

Lumber cutting diagram Lengths chosen for the lowest cost; 1/8 in kerf, 1/2 in end trim

4x4 PT x 8 ft
Brace post start 1 94
4x4 PT x 8 ft
Brace post start 2 94
4x4 PT x 8 ft
Brace post end 1 94
4x4 PT x 8 ft
Brace post end 2 94
4x4 PT x 8 ft
Brace start 92 1/2
4x4 PT x 8 ft
Brace end 92 1/2

Shopping list $213.14 checked / $15.00 estimated

ItemStoreQtyEachLineNote
4x4x8 ground-contact pressure-treatedHome Depot6$11.28$67.68see lumber cutting diagram
Woven wire fence 47 in, 100 ft (one third of a 330 ft roll, $244.99)Tractor Supply1$74.24$74.24woven wire, cut from a 330 ft roll
6 ft studded T-post (1.25 lb/ft)Tractor Supply8$4.49$35.92
UV zip ties 11 in, 100 ct (also used for tie wire)Home Depot2$17.65$35.30T-post clips and brace wire
Fence staples, 1.5 in, 5 lbTractor Supply1$15.00$15.00fence staples
Total before tax~$228.14
Filled dot: price read from a store listing on Oct 20, 2026. Hollow dot: estimate. Prices come from the master price list, so they change when it changes.

Build steps

  1. Dig the four brace post holes 36 in deep and set the two H-braces at the ends: 8 ft apart, a 4x4 brace between them and a tie wire diagonal.
  2. Stretch a string between the braces and drive 8 T-posts, 24 in into the ground, 10 ft apart, with the studs toward the animals.
  3. Roll the woven wire along the posts, with the closer spacing at the bottom, and tie one end to the first brace post.
  4. Stretch the wire with a fence stretcher or a come-along on the far brace, until it springs back when pushed.
  5. Clip or tie the wire to each T-post at the top and bottom, and staple it to the braces. Add a hot wire at the top for horses.

Before you start